357
Kaleido-X
User’s Manual
10 In the Properties pane, set the serial
communications properties for the Kayak device as
follows:
Assigning Kayak Tallies, Input Names, and Output
Names to Logical Sources
To configure your logical sources
•In the Channels/Sources tab, configure logical sources using text sources and system
tallies from the Kayak’s serial interface.
Baud Rate 38400
Data Bits 8
Parity NONE
Stop bits 1
Notes
• Kayak devices provide up to 512 text sources, and up to 256 × 5 system
tally sources.
• The current version of the XtenDD HD/SD switchers software does not
provide tally sources.
• DD35 and the Kayak series switchers only provide RED (On Air) tally
sources. This is a limitation in the current version (6.9.3) of the ACOS
protocol.
• Refer to the table below for a list of valid sources, depending on your
switcher model, and their meaning in the context of the ACOS protocol.
Input
Number
DD35 XtenDD HD XtenDD SD KayakDD Kayak SD/HD
0x00 BLACK BLACK BLACK BLACK BLACK
0x01..0x60 Input1...62
(0x01..0x3E)
Input 1..90
(0x01..0x5A)
Input 1..90
(0x01..0x5A)
Input 1..32
(0x01..0x20)
Input 1..96
(0x01..0x60)
0x80 VideoStore
To Next Page
Loading...
