211
Kaleido-X
User’s Manual
The image appears in the layout background.
Setting up a Layout for Background Keying from the DVI Input
Kaleido-X and Kaleido-X16 multiviewers have a DVI input connector for every output head.
Using these connectors, it is possible to feed keying material to the multiviewer. Depending
on your purposes, the content provided through the DVI input can be set either as a
background or as a foreground for the layout shown on the monitor wall (see
Calibrating
the DVI Keying Mode, on page 117). This section explains how to set up a layout’s
background to be keyed out and replaced with content from the DVI input.
To use the DVI input as the background in a layout
1 Click the background of the layout.
2 In the Properties pane, click the Background color box, and then click the button that
appears inside the box to open the Pick a Color window.
Notes
• The Kaleido-IP and KMV-3901/3911 multiviewers do not support DVI
keying.
• Since the DVI input cannot be resized, the resolution on the PC that feeds
this input is best set to match the selected display’s (head) resolution. The
DVI background is always positioned from the top-left corner of the
display and is drawn pixel for pixel. If the resolutions do not match, some
part of the DVI input might be missing or noise might be displayed.
To Next Page
Loading...
