47
Kaleido-X
User’s Manual
The Assign Source window appears.
The label of each category/index button in Assign Source is based on recurring strings
found in the logical source names available for your system. The Src box shows the
current assignment.
3 Click through the categories until the Pst box shows the logical source you wish to
assign to the selected monitor. For example, if you wish to assign the logical source
named “/Input B/Channel 16” to the monitor, click Input B, 1, and then 6.
4Click Take.
The selected logical source is now assigned to the monitor.
5 Click the × button to close the Assign Source window.
Changing Crosspoints
Changing Logical Sources Assignments on a Kaleido-X Configured as a
Router
To change a monitor’s source assignment by using a router control device or application
• Apply a crosspoint change to route the desired Kaleido-X logical source to the video
monitor whose source assignment you wish to change on the monitor wall, in the same
way you would do for any router controlled by the device or application you have.
To Next Page
Loading...
