403
Kaleido-X
User’s Manual
Specifying Multiviewers for the RCP-200
To specify a multiviewer for the RCP-200
1 Press the CONFIG button, located between the two screens on the front of the RCP-200.
2 Touch the COMM category on the right-hand screen.
3 Touch the KALEIDO DISCOVERY tab on the right-hand screen.
4 Use the four control knobs in the ADD TO LIST area to dial in the IP address of the
multiviewer you wish to operate.
The address appears in the TO ADD box.
5 Press the ADD control knob.
The multiviewer’s IP address appears in the LOOKUP LIST area.
6 Press the CONFIG button, located between the two screens on the front of the RCP-200
to end the configuration process and return to normal operation.
Specifying Lookup Servers for the RCP-200
The RCP-200 needs to connect to a lookup server in order to control devices, including a
multiviewer’s KX
router logical router.
To specify a lookup server for the RCP-200
1 Press the CONFIG button, located between the two screens on the front of the RCP-200.
2 Touch the COMM category on the right-hand screen.
3 Touch the DISCOVERY tab on the right-hand screen.
4 Use the four control knobs in the ADD TO LIST area to dial in the IP address of the
multiviewer you wish to operate.
The address appears in the TO ADD box.
5 Press the ADD control knob.
The multiviewer’s IP address appears in the LOOKUP LIST area.
6 Press the CONFIG button, located between the two screens on the front of the RCP-200
to end the configuration process and return to normal operation.
Logging on to the RCP-200
Note: In a default system configuration, a multiviewer’s video outputs are
assigned to specific rooms:
• On a Kaleido-X (7RU), the two DVI/VGA outputs from each of the dual-
head Output cards A, B, C and D are assigned to ROOM1, ROOM2, ROOM3
and ROOM4 respectively.
• On a Kaleido-X (4RU), the two DVI/VGA outputs from each of the dual-
head Output cards A and B are assigned to ROOM1 and ROOM2
respectively.
• On a Kaleido-X (14RU) expansion system, the two DVI/VGA outputs from
each of the dual-head Output cards A, B and C of each of Frame A and
Frame B are assigned to ROOM1, ROOM2, ROOM3, ROOM4, ROOM5 and
ROOM6 respectively.
To Next Page
Loading...
