325
Kaleido-X
User’s Manual
5In the Interconnects tab, click the router controller icon. Under the Properties tab, a list
of settings appears, with default values for the serial communication parameters: the
bit rate (bps), the number of data bits, parity, stop bits and flow control.
However, in this case, there is no Router box for specifying which logical router is to be
controlled. This is because the SW-P-08 protocol allows the controller to pass the
identifier for the logical router with a command (i.e. it tells the multiviewer to make a
crosspoint change for logical router X). The ID that it passes is the logical router matrix
ID (refer to
Step 3 – Adding Logical Routers, on page 314).
6Click the Router configurations tab to view (or set) the logical matrix ID.
To Next Page
Loading...
