Mitsubishi FX3U Series User Manual

18
Requirement for Compliance with LVD directive
The following products have shown compliance through direct testing (of the identified standards below) and
design analysis (through the creation of a technical construction file) to the European Directive for Low
Voltage (73/23/EEC) when used as directed by the appropriate documentation.
Type : Programmable Controller (Open Type Equipment)
Models : MELSEC FX
3U series manufactured
Models : MELSEC FX
2N series manufactured
For the products above, PLCs manufactured
before March 31st, 2002 are compliant with IEC1010-1
from April 1st, 2002 to April 30th, 2006 are compliant with EN61131-2:1994+A11:1996+A12:2000
after May 1st, 2006 are compliant with EN61131-2:2003
from May 1st, 2005 FX3U-MR/ES
Where  indicates:16,32,48,64,80
from November 1st, 2005 FX
3U-MT/ES FX3U-MT/ESS
Where  indicates:16,32,48,64,80
from February 1st, 2006 FX
3U-128MR/ES FX3U-128MT/ES FX3U-128MT/ESS
FX
3U-MR/DS
Where  indicates:16,32,48,64,80
Standard Remark
EN61131-2:2003 Programmable controllers
- Equipment requirements and tests
The equipment has been assessed as a component for
fitting in a suitable enclosure which meets the requirements
of EN61131-2:2003
from July 1st, 1997 FX
2N-ER-ES/UL FX2N-ET-ESS/UL
Where  indicates:32,48
FX
2N-16EYR-ES/UL
from April 1st, 1998 FX
2N-48ER-DS
from August 1st, 1998 FX
2N-48ER-UA1/UL
from August 1st, 2005 FX
2N-8ER-ES/UL FX2N-8EYR-ES/UL
Standard Remark
IEC1010-1:1990 Safety requirements for electrical
/A1:1992 equipment for measurement, control,
and laboratory use
- General requirements
The equipment has been assessed as a component for
fitting in a suitable enclosure which meets the requirements
of IEC 1010-1:1990+A1:1992
EN61131-2:1994 Programmable controllers
/A12:1996 - Equipment requirements and tests
/A11:2000
The equipment has been assessed as a component for
fitting in a suitable enclosure which meets the requirements
of EN61131-2:1994+A11:1996+A12:2000
EN61131-2:2003 Programmable controllers
- Equipment requirements and tests
The equipment has been assessed as a component for
fitting in a suitable enclosure which meets the requirements
of EN61131-2:2003

Mitsubishi FX3U Series Specifications

General

Model	FX3U Series
Program Memory	64k steps
Execution Speed	0.065 μs/basic instruction
Type	PLC (Programmable Logic Controller)
Power Supply	100-240V AC
I/O Points	Up to 384
Communication	USB
Expansion	Supported via expansion modules
High-Speed Counters	Up to 6 channels
Analog Input/Output	Available via expansion modules
Temperature Range	0 to 55°C
Programming Language	Ladder Logic, Structured Text
Built-in Functions	PID control
Humidity	5 to 95% (non-condensing)