Mitsubishi FX3U Series User Manual

FX3U Series Programmable Controllers
User’s Manual - Hardwaer Edition
99
6 Examination of System Configuration
6.7 Expansion of Extension Power Supply Unit (FX3U-1PSU-5V)
1
Introduction
2
Features and Part Names
3
Product Introduction
4
Specifications
5
Version and Peripheral Devices
6
System Configuration
7
Input/Output Nos., Unit Nos.
8
Installation
9
Preparation and Power Supply Wiring
10
Input Wiring
6.7 Expansion of Extension Power Supply Unit (FX3U-1PSU-5V)
If the selected devices in section 6.5 are not connectable due to the built-in 5V DC power shortage, add an
extension power supply unit.
1 Enter the current supply specification of the extension power supply unit.
The output current of the extension power supply unit is proportional to the ambient temperature as
shown by the derating curve below. Enter the output current value, based on this derating curve.
Also verify that the number of occupied input/output points from input/output extension block(s)
connected to the extension power supply unit is less than 32.
Power
supply
classification
Classification
Number of
connected
units
Type
Capacity of built-in power
supply
Connectable
I/O occupied
points
[points]
5V DC power
supply [mA]
Power supply
for internal
24V DC [mA]
With built-in
power supply
Extension
power supply
unit
− FX
3U-1PSU-5V 32
0.8
1.0
Ambient temperature [°C]
5540
0.3
0.2
5V DC
Output current [A]
24V DC
0
Derating curve
5
5- 1 5- 2 5- 3
H1

Mitsubishi FX3U Series Specifications

General

Model	FX3U Series
Program Memory	64k steps
Execution Speed	0.065 μs/basic instruction
Type	PLC (Programmable Logic Controller)
Power Supply	100-240V AC
I/O Points	Up to 384
Communication	USB
Expansion	Supported via expansion modules
High-Speed Counters	Up to 6 channels
Analog Input/Output	Available via expansion modules
Temperature Range	0 to 55°C
Programming Language	Ladder Logic, Structured Text
Built-in Functions	PID control
Humidity	5 to 95% (non-condensing)