ScreenWorks Software Overview
118 0112-0109 H
The table below describes the options available on the Mix Fluid
process page:
Item Description
Mix Plate Select the plate that has the fluid to be mixed. Typically,
it is a source plate from which you will be transferring
fluid.
Quadrant If appropriate, select a quadrant from which fluid is
mixed.
Note: Quadrant selection is only available when
liquid is dispensed to a plate using a pipettor
head of lower density, for example, 384-well plate
using a 96 pipettor head.
Volume Enter volume (in μL) to mix.
Speed Enter speed (in μL/s) to mix the fluid.
Height Enter distance (in μL) from the bottom of the well that
the tips will be inserted prior to mixing.
Note: Tips move up and down with aspirate and
dispense commands. These movements help to
prevent well overflow when the tips are
submerged.
Expel Volume Enter an additional volume (in μL) the pipettor
dispenses, beyond the volume entered in the Volume
field above. This helps to ensure that all fluid is expelled
from the tips after mixing.
Strokes Enter number of times to aspirate and dispense mix
volume. One stroke is equal to one aspiration and one
dispense.
Removal Speed Enter rate (in mm/s) at which tips are pulled from well
immediately after the mix. This value is adjusted for
fluid viscosity or fluid volume in the well.
Pause In Well Enter time (in seconds) to pause with the tips in the well
after mixing and before the next pipettor head move.
Unload Tips
After Mix
Automatically unloads tips after the mix step.
To Next Page
Loading...
Need help?
General
