FLIPR
®
Tetra High Throughput Cellular Screening System User Guide
0112-0109 H 255
• Response will be OK confirming the software has attempted to
clear the error.
• Monitor status for error is cleared.
Loadtips<CR>
Command Description
This command loads the tips onto the pipettor head from position s1.
This command will execute when commanded if tips are not already
loaded and any plate is in the tips position. The instrument is not
capable of confirming that the plate in the tip load position is actually a
tip rack. It is the responsibility of the user to ensure that the plate in
that position is actually a tip rack. Attempting to load tips when a plate,
rather than a tip rack, is in the tip load position will likely result in an
instrument fault and may result in damage to the plate, the instrument,
or both.
Command Parameters
There are no parameters associated with this command.
Example Command Line
loadtips<CR>
Example Response
ok<CR>
Suggested Steps in Command Usage
• Make sure an experiment is not running.
• Check the instrument status to make sure tips are not already
loaded.
• Place tiprack in tipload position via the loadplate command.
• Send loadtips command.
• Response will be OK, confirming that command execution has
begun, or a Condition code related to the command indicating
that execution could not begin.
• Monitor status for completion, and error status for any other
kind of error.
Command Specific Error Responses
• Can't load tips, tips on pipettorCondition code is C58
To Next Page
Loading...
Need help?
General
