0112-0109 H 43
4
Software Installation
This chapter describes how to install ScreenWorks
®
System Control
Software.
You must have administrative privileges on the computer operating
system to install ScreenWorks Software.
Installing ScreenWorks Software
As of version 3.1, the installer automatically uninstalls the old software
version as long as it is same major release (3.1 to 3.2). If you are
replacing ScreenWorks Software version 2.0 manually uninstall the old
software before installing the new software. See Uninstalling
ScreenWorks Software on page 46.
1. Double-click the ScreenWorks_3_2_x.exe ScreenWorks
Software installation file. A Welcome to the ScreenWorks Setup
Wizard dialog is displayed.
2. Click Next.
3. In the License Agreement dialog box, select I accept the
terms of the license agreement, and click Next.
4. In the Online/Offline Mode dialog, designate the default mode
in which you want the software to start.
In Online, ScreenWorks Software automatically looks for a
connected instrument when the software is started.
In Offline, ScreenWorks Software does not automatically
look for a connected instrument.
Refer to Online vs. Offline Installation on page 45 for further
details.
5. Click Next.
6. In the Destination Folder dialog, the Install ScreenWorks
3.2 to field displays the default installation directory. To change
the installation directory, click Change, navigate to the desired
directory, then click OK.
7. Click Next.
8. In the Select Program Folder dialog, leave the displayed
default Program Folder settings. Select Anyone who uses
this computer to make ScreenWorks Software available to all
users on the FLIPR
®
Tetra System host computer, then click
Next.
To Next Page
Loading...
Need help?
General
