3 Product description
Maschinenfabrik Reinhausen 2014 212374092/04 EN TAPCON® 260
Unit Measured value
Phase Phase angle
Cos Active factor: Cosine φ [phi] (output factor)
Table 5: Measured value display
Current messages and events are displayed in the status line . You can
find more information about messages and events in the Messages [► 144]
chapter.
Serial interface
The parameters for the device can be set using a PC. The COM 1 (RS232)
serial interface on the front panel is provided for this purpose. You can use
the connection cable supplied to establish a connection to your PC via the
RS232 or USB port (using the optional USB adapter).
TAPCON®-trol software is needed for parameterization via the serial inter-
face. The software and the related operating instructions are contained on
the CD provided.
Figure 7: Device connection to a PC
Assemblies
Depending on configuration, the device may have various assemblies which
perform the functions required. Depending on configuration, the device may
be equipped with the following assemblies:
Status line
3.5.4
3.5.5
To Next Page
Loading...
