EFA-200/-300 7 Measurement data memory
7-5
Defining a time period for saving data
✓ The MEM AUTO menu is open.
1. Use the UP/DOWN keys to select the “START” function.
2. Press ENTER to confirm your selection.
The first entry field for the start time is highlighted in black.
3. Use the UP/DOWN keys to define a value.
4. Press the NEXT key to move to the next entry field.
5. Repeat steps 3 and 4 for the remaining entry fields.
6. Press ENTER to complete entry.
The measurement start time has been entered.
7. Repeat steps 1 through 6 for the “STOP” and “STEP” (time between two
measurements) functions.
The start, stop and step times are now set and are displayed in the MEM
AUTO menu.
8. Press key F4.
• The measurement will start precisely at the start time and end at the
stop time specified.
• The number of data sets MEM already saved and the last
measurement value saved are displayed.
• Progress of the measurement can be observed.
• Keys F1 and F4 change function.
– F1: no function
– F4: BREAK – breaks off the measurement sequence
Recording spatially assigned measurement sequences
(MATRIX): see page 7-7
– or –
Starting data storage immediately
1. Use the UP/DOWN keys to select the “STEP” function.
2. Press ENTER to confirm your selection.
The first entry field for the step time is highlighted in black.
3. Use the UP/DOWN keys to define a value.
4. Press the NEXT key to move to the next entry field.
5. Repeat steps 3 and 4 for the remaining entry fields.
6. Press ENTER to complete entry.
The measurement step time has been entered.
To Next Page
Loading...
