7 Measurement data memory EFA-200/-300
7-12
Changing the target coordinates
The target coordinates can be changed within the defined spatial area at
any time.
⇒ Press the UP key.
The next target coordinate is calculated and displayed.
– or –
⇒ Press the DOWN key.
The previous target coordinate is calculated and displayed.
– or –
⇒ Press F2.
The target coordinate changes to the coordinates of limit “A”.
Note: No values are saved when you change the target coordinates. A
further measured value is stored in the data pool only when the
SAVE key is pressed.
Reaching the range limits
When the target coordinate reaches one of the spatial limits defined by the
limits “A” and “B”, the calculation shifts to the next directional axis in the
coordinate ranking. A single beep indicates the change of direction. A
double beep indicates that the target coordinate has reached one of the limit
values “A” or “B”.
Deleting a measured value from the data pool
⇒ Press F1.
The last measured value saved in the data pool will be deleted without
changing the indicated target coordinates.
Saving a data set
At the conclusion of the measurement, all the measured values recorded
and saved in the data pool are stored as a contiguous data set.
1. Press F4.
This returns you to the MEM MATRIX sub-menu.
To Next Page
Loading...
