Loading Files via Drag and Drop
Except for Projects, you can also load files from the Result list into the desired location via
drag and drop. This notably has the following benefits:
▪ You can load the file into a Group or a Sound slot that is not currently focused, or into a
Plug-in slot that is not selected.
▪ You can load a Sample into its own Zone in the Zone page of the Sample Editor: A new
Zone will be created for that Sample. See section ↑14.5.7, Adding Samples to the Sample
Map for more information.
Drag and drop of Groups and Sounds is possible only in Arrange view.
Loading Multiple Files at Once via Drag and Drop
Once you have selected multiple files from the Result list (see description above), you can drag
and drop them to the relevant locations in MASCHINE. By doing this, please keep in mind the
following:
▪ When dragging several Groups onto the Group List, you have following options:
◦ If you drop the Groups between two existing Groups (where the insertion line appears),
the dropped Groups will be inserted between these two Groups.
◦ If you drop the Groups onto an existing Group, the dropped Groups will replace that
Group and the following ones.
◦ If you drop the Groups onto the “+” at the end of the Group List, the Groups will be
appended to the existing Groups in the Group List.
▪ When dragging several Sounds, you have following options:
◦ If you drop the Sounds onto an existing Group, the Sounds will be loaded in the empty
Sound slots of that Group — if there are not enough empty Sound slots, the Sounds
will be loaded in the first Sound slots of the Group, replacing the Sounds previously
loaded in these slots.
◦ If you drop the Sounds onto the “+” at the end of the Group List, the Sounds will be
loaded in a new Group appended to the existing Groups.
Browser
Searching and Loading Files from the Library
MASCHINE STUDIO - Manual - 149
To Next Page
Loading...
Need help?
General
