→
Your controller switches to Section mode. This is indicated by the highlighted SECTION
in the upper-left corner of the left display.
Apart from a few commands, the main difference between the Section mode and the Section
Arrange mode is found in the right display of the controller: In Section mode you see all Sec-
tion slots of the selected Section bank represented as a square of 4x4 cells:
▪ The highlighted cell indicates the selected Section slot.
▪ Cells showing a name represent Section slots referencing a Scene.
▪ Empty cells represent empty Section slots.
This grid of cells shown in the right display corresponds to the pads of your controller, which
have the same functionality as in Section Arrange mode:
▪ The fully lit pad indicates the selected Section slot.
▪ Dim lit pads indicate Section slots referencing a Scene.
▪ Unlit pads represent empty Section slots.
In addition, the Section mode provides useful Section management commands similar to those
of the Section Arrange mode. These are described in the following sections.
13.3.2 Creating Sections
You can create a new Section directly in the Arranger view.
Creating a Section using the Software
►
To create a new Section, click the “+” button located after all existing Section names in
the top row of the Arranger view.
Working with the Arranger
Using Arranger View
MASCHINE STUDIO - Manual - 775
To Next Page
Loading...
Need help?
General
