5. Click the little field on its left to select a MIDI channel.
This is equivalent to the Channel parameter described above.
For more information on how to trigger MASCHINE 2 sounds via MIDI Notes in a host
Sequencer refer to this Knowledge Base Article: http://www.native-instruments.com/
knowledge/questions/1780/.
8.2.2 Triggering Scenes via MIDI
The MASCHINE hardware SCENE mode can be configured to send out MIDI (Notes/Program
Changes) which can be used to trigger scenes. When MASCHINE runs as a Plug-in this MIDI
data is sent to the host application. When MASCHINE runs as a stand-alone application this
MIDI data is send out to all activated MIDI output devices.
MIDI Scene Change program change messages can be used to record a Scene performance to
a host application, and all recorded Scene performances can be then be saved within your
DAW and sent back to MASCHINE for playback and trigger Scenes in the recorded order.
To send MIDI Scene Change messages:
1. Click the cog wheel Icon in the Header of the MASCHINE software.
2. Select MIDI Scene Change.
Audio Routing, Remote Control, and Macro Controls
Using MIDI Control and Host Automation
MASCHINE STUDIO - Manual - 480
To Next Page
Loading...
Need help?
General
