→
A new empty Pattern is created in the selected Pattern slot. The new Pattern is loaded in
the Pattern Editor with an empty Event area. Furthermore, this Pattern is referenced by a
Clip for the selected Group in the current Scene in the Arranger. This Clip replaces any
previous Clip for the Group in that Scene (see chapter ↑13.3, Using Arranger View for
more on this).
7.7.3.1 Creating a New Pattern on Your Controller
â–º
To create a new empty Pattern in the current Pattern bank, press PATTERN + any unlit
pad.
→
A new empty Pattern is created at this position in the current Pattern bank. Additionally:
▪ The new Pattern is selected and displayed in the software’s Pattern Editor. You can then
modify it both from your controller and in the software.
â–ª The new Pattern is referenced by a Clip for the selected Group in the current Scene. This
Clip replaces any previous Clip for the Group in that Scene (see chapter ↑13.3, Using Ar-
ranger View for more on this).
You don’t need to explicitly create a new empty Pattern before filling it with events: If
no Pattern is selected, as soon as you record events a new Pattern will be created for
them! See section ↑7.4.2, Creating Events/Notes for more information on creating
events.
7.7.4 Deleting Patterns
To delete a Pattern:
1. Open the Pattern Manager (see ↑7.7.1, The Pattern Manager and Pattern Mode).
2. If necessary, select the Pattern bank containing the desired Pattern by clicking its pad
grid on the right.
The selected Pattern bank is surrounded by a white border and its Patterns appear in the
list on the left.
Working with Patterns
Managing Patterns
MASCHINE STUDIO - Manual - 422
To Next Page
Loading...
Need help?
General
