The Event area will stop following the playhead as soon as you manually scroll to anoth-
er portion of the Pattern.
The Follow function simultaneously affects various displays in the software and on your con-
troller:
â–ª In the software the Follow function affects both the Pattern Editor and the Arranger.
â–ª On your controller the Follow function affects the displays in Arrange mode (for SECTION,
SCENE and PATTERN pages), Events mode, Step mode, and Note Repeat mode. Addition-
ally, in Step mode the Follow function affects the pads: With Follow enabled, when the
playhead has gone across all 16 steps shown by the pads on your controller, the pads
switch to the next 16 steps of the Pattern, if any. See section ↑7.3, Recording Patterns
with the Step Sequencer for more information on Step mode.
If the playback position is outside any Pattern currently displayed, the Event area will
not follow the playhead, even if the Follow function is active. As soon as the playhead
enters a selected Pattern, the Event area will follow the playhead.
7.1.4 Jumping to Another Playback Position in the Pattern
You can use the timeline above the Event area to set the playback to the desired position. For
example, this can be useful to check a particular transition between events in your Pattern
without waiting for the whole Loop Range to be looped.
In the timeline above the Event area, a playhead (the little white vertical line) indicates the
current play position in the Pattern.
The playhead in the timeline shows you the current play position.
Working with Patterns
Pattern Basics
MASCHINE STUDIO - Manual - 345
To Next Page
Loading...
Need help?
General
