Parameter Description
NEW BPM
(Beat mode only)
Defines the target tempo of the time-shifted audio (in BPM).
LENGTH
(Stretch Length,
Beat mode with Auto
Detection enabled
only)
If AUTO DTCT is enabled, you can define the length of the target
audio (in bars). Please note that any change to the SRC BPM value
(see above) will be automatically mirrored by this LENGTH value. Once
you have set the number of bars in the source audio, you can set here
another number of bars, thereby dividing or multiplying the tempo of
the target audio. Available values are 1/16, 1/8, 1/4, 1/2, 1, 2, 4, and
8 bars, as well as the corresponding triplet values.
SPEED
(Free mode only)
Adjusts the new tempo relative to the original tempo (in percentage).
The minimum value is 10 %.
In Beat mode, if you set a target tempo (NEW BPM) that is smaller than a tenth of the
original tempo (SRC BPM), Button 8 (APPLY) will be grayed out and disabled. Set a
higher target tempo to enable the button again!
â–º
Once you have set the parameters to the desired values, press Button 8 (APPLY) to apply
the pitch shifting and/or time stretching to the selected region in the Sample. If you don’t
want to use the Stretch function, press Button 7 (SETTINGS) again to switch back to the
audio function selection.
14.4 Slicing a Sample
Slicing allows you to chop up loops to extract single Sounds (the drum sounds of a drum loop
for example), but it's also good for preparing a loop to be played back at another tempo without
changing its pitch or timing. The resulting Slices can then be exported to different notes of the
same Sound or to different Sounds of the same Group.
The Slice page of the Sample Editor in the software and its equivalent the SLICE page of the
Sampling mode on your controller allow you to slice your Samples in various ways.
The typical workflow for slicing your Samples is as follows:
Sampling and Sample Mapping
Slicing a Sample
MASCHINE STUDIO - Manual - 838
To Next Page
Loading...
Need help?
General
