10.3.10 Snare – Breaker
The Breaker snare is an acoustic high pitched snare drum that cuts through perfectly into mix-
es containing heavy bass. The adjustment of the wires spectrum provides a great range of
snares. It also works very well with the Rasper Kick.
The parameters described below are presented as they appear in the Control area (Ar-
range view). The same parameters are available in the Plug-in panel within the Plug-in
Strip (Mix view). See ↑9.4, The Plug-in Strip for more information on this.
Main Page
Element Description
MAIN Section
Engine Selects the engine used in the Snare plug-in. For more information
on the available engines, please refer to section ↑10.3, The Snares.
Tune Adjusts the pitch of the drum played by the middle C, measured in
MIDI note numbers and cents. Available values range from 61.00
(NOTE C#3) to 85.00 (NOTE C#5). The default value is 73.00
(NOTE C#4).
Decay Adjusts the duration of the sound’s tail, measured as a percentage.
Available values range from 0.0 to 100.0% (default: 50.0%).
Skin Tune Adjusts the fine-tuning of the skin of the drum, measured as a
percentage. Available values range from 0.0 to 100.0% (default:
50.0%).
Impact Adjusts the amount of click or initial attack, measured as a
percentage. Available values range from 0.0 to 100.0% (default:
75.0%).
Advanced Page
For this engine the Advanced page does not contain any parameters.
Using the Drumsynths
The Snares
MASCHINE STUDIO - Manual - 582
To Next Page
Loading...
Need help?
General
