Native Instruments MASCHINE STUDIO User Manual

To assign the selected pad(s) / Sound slot(s) to a Link group and set its/their Link mode on
your controller:
1. Hold the PAD MODE button to enter Pad Mode (or press PAD MODE + Button 1 to pin it).
2. If necessary, press the Page Left button to switch to the first Parameter page of the Pad
Mode.
3. Turn Knob 3 (LINK GROUP) to select the desired Link group 1–8 for that pad or choose
NONE (default setting) to remove the pad from its current Link group.
4. Turn Knob 4 (LINK MODE) to select the Link mode from MASTER (default setting) or
SLAVE for that pad.
5. Release PAD MODE (or press it again if you pinned the mode).
5.2 Adjusting the Key, Choke, and Link Parameters for Multiple Sounds
In the software, if you select multiple Sounds with different Key, Choke and/or Link values, the
corresponding parameters in Pad view now display MULTI. On your controller in Pad Mode, the
corresponding parameters now display (MULTI).
Moreover, you can adjust these parameters for the selected Sounds as described below.
For general information on the Pad view of the software, the Pad Mode on your control-
ler, and the Key, Choke, and Link parameters, please refer to section 5.1 “Adjusting
Your Pads” in the MASCHINE 2.0 Manual.
Adjusting the Key Parameter for Multiple Sounds with different Key Values
►
Click and drag the MULTI label next to Key to transpose the base key of all selected
Sounds. While dragging, the field displays a +/-x value indicating the transposition that
will apply to all Sounds as you release the mouse button.
Playing on Your Controller
Adjusting the Key, Choke, and Link Parameters for Multiple Sounds
MASCHINE STUDIO - Manual - 250

Native Instruments MASCHINE STUDIO Specifications

General

Brand	Native Instruments
Model	MASCHINE STUDIO
Category	Recording Equipment
Language	English