Sampler parameters – page 3 of 6: FX and FILTER in the software.
FX
This is a small selection of basic effects, not to be mixed up with the collection of Effect Plug-
ins covered in depth in chapter ↑12, Effect Reference.
Parameter Description
FX
Comp Basic compressor allowing you to give a Sound more density.
Drive Defines the amount of saturation applied to a Sound.
SR SR stands for “sample rate”: you can use it to lower the original
sample rate in order to make the Sound more lo-fi.
Bits Allows you to lower the original bit depth of the Sound, resulting in a
more rough, digital sounding lo-fi effect.
FILTER
The Filter selector in the FILTER section gives you access to a set of different filters. Using the
arrows or clicking the type currently displayed, you can choose from different filter type set-
tings: Off, LP2, BP2, HP2, and EQ. Each type results in different parameters to the right of it:
Filter Modes Description
Off No filter.
LP2 LP2 is a low-pass filter with Cutoff and Resonance parameters.
Cutoff can be modulated by Velocity, the Modulation Envelope, the
LFO or the MIDI Modulation Wheel.
Working with Plug-ins
The Sampler Plug-in
MASCHINE STUDIO - Manual - 315
To Next Page
Loading...
Need help?
General
