MODULATION ENVELOPE
The MODULATION ENVELOPE section offers an additional envelope allowing further modifica-
tion (or “modulation”) of specific Sampler parameters according to the way you play on the
pads. Its parameters are matched to those of the AMPLITUDE ENVELOPE section on page 2
(see ↑6.2.1, Page 1: Voice Settings / Engine), so that you have either an ADSR (Attack, Decay,
Sustain, Release) envelope or an AHD (Attack, Hold, Decay) envelope to modulate your param-
eters. If you choose One-shot mode, only the AHD envelope (pictured) will be available for
modulation.
Envelope Controls Description
Attack The time it takes for the envelope to reach its maximum level.
Hold How long the envelope will stay at its maximum level.
Decay With Decay you adjust how fast the envelope drops to the sustain
level in ADSR mode; in AHD mode it is used to adjust how fast the
envelope fades out.
Sustain The envelope level that will be maintained as long as the note is
played.
Release The time for the sustain level to return to zero after the note has
ended.
DESTINATION
This is where you define modulation targets for the modulation envelope, i.e. the parameters
you want this envelope to control. The knobs adjust the amount of modulation for the following
targets:
Parameter Modulation Destination
Pitch Tune parameter of the PITCH / GATE section on the Pitch / Envelope
page (page 2).
Cutoff Cutoff parameter of the FILTER section (with filter types LP2, HP2,
BP2 only) on the FX / Filter page (page 3).
Working with Plug-ins
The Sampler Plug-in
MASCHINE STUDIO - Manual - 317
To Next Page
Loading...
Need help?
General
