â–º
Click the metronome icon in the MASCHINE Header to enable/disable the metronome:
The metronome can be heard only when the sequencer is playing!
The metronome signal is sent to the Cue bus. To know how to use the Cue bus, see section
↑9.2.6, Using the Cue Bus.
You can customize the metronome in various ways in the Preferences panel:
▪ You can adjust the metronome’s volume and time signature in the Preferences’ General
page (see section ↑2.6.1, Preferences – General Page for more details).
▪ You can select custom sounds for the metronome’s downbeats and upbeats in the Prefer-
ences’ Default page (see section ↑2.6.4, Preferences – Default Page for more details).
The time signature of the metronome can be set to differ from the time signature of your
Project! This can be useful to record unusual rhythms in a Pattern. Reminder: the time
signature of your Project is defined in the MASCHINE Header (MASCHINE in stand-
alone mode) or by your host application (MASCHINE running as a plug-in).
On your controller:
â–º
Press METRO in the TRANSPORT section to activate or deactivate the metronome.
Adjusting the Metronome’s Volume and Time Signature
On your controller you can adjust the volume and time signature of the metronome in the re-
cording settings:
Working with Patterns
Recording Patterns in Real Time
MASCHINE STUDIO - Manual - 363
To Next Page
Loading...
Need help?
General
