Closing the Pattern Manager
►
To close the Pattern Manager, click anywhere outside it.
The Pattern Mode on Your Controller
The Pattern mode is where you select and manage your Patterns.
►
To enter Pattern mode on your controller, press PATTERN (you can pin it by pressing
Button 1 at the same time).
→
Your controller switches to Pattern mode. This is indicated by the lit PATTERN button.
The hardware displays in Pattern mode.
On the right display, you will see all available Pattern slots in the selected Pattern bank repre-
sented as a square of 4x4 cells:
▪ The highlighted cell indicates the selected Pattern slot.
▪ Cells showing a name represent Pattern slots containing a Pattern.
▪ Empty cells represent empty Pattern slots.
This grid of cells corresponds to the pads on your controller:
▪ The fully lit pad indicates the selected Pattern slot.
▪ Dim lit pads indicate Pattern slots containing a Pattern.
▪ Unlit pads represent empty Pattern slots.
Working with Patterns
Managing Patterns
MASCHINE STUDIO - Manual - 418
To Next Page
Loading...
