The Flanger panel in the Plug-in Strip.
The Flanger in the Control area.
Parameter Description
MAIN Section
Frequency This defines the center frequency of the Flanger.
Feedback Adjusts the amount of output signal fed back into the input.
Invert Inverts the Flanger.
MOD Section
Amount This defines how much the Flanger gets modulated by the
modulation source.
Source Here you can select the modulation source of the Flanger: available
options are LFO, LFO Sync, and Envelope. Depending on your
selection, the parameter to the right will change.
Speed (LFO) Defines the speed of the LFO in a range from 0.03 Hz up to 8 Hz.
Effect Reference
Modulation Effects
MASCHINE STUDIO - Manual - 686
To Next Page
Loading...
Need help?
General
