Then create the Pattern for the desired Group:
1. Press the desired Group button A–H to select the Group from which you want to select a
Pattern.
2. Press and hold PATTERN.
Both your pads and the right display give you an overview of the available Patterns. Dim lit
pads indicate the available Patterns. If a Pattern already exists in the selected Scene for that
Group, the referenced Pattern is highlighted and its pad is fully lit.
1. While you are holding PATTERN, press Button 7 or 8 to select the desired Pattern bank,
then press the desired pad (or press the Page buttons) to select the Pattern you want to
use in that Scene.
→ If you have pressed a dim lit pad, a Pattern is inserted into the selected Scene. If you
have pressed an unlit pad, a new empty Pattern is automatically created in the selected
Scene. In both cases, any Pattern previously existing for that Group in the Scene will be
replaced.
Furthermore, the following happens:
â–ª In the Arranger (Ideas view and Arranger view) the Pattern displays the name and color of
the Pattern.
â–ª The corresponding Pattern will now be played by that Scene.
â–ª Additionally this Pattern is loaded in the Pattern Editor, ready to be modified.
For further information regarding the Pattern mode, please refer to section ↑7.7, Manag-
ing Patterns.
Removing a Pattern from a Scene on the Controller
Removing a Pattern is also done in Pattern mode:
â–º
To remove the Pattern for the selected Group from the selected Scene, press PATTERN +
Button 2 (REMOVE).
→
The Pattern is removed from the Scene:
â–ª The corresponding Pattern will not be played by that Scene anymore.
Working with the Arranger
Using Ideas View
MASCHINE STUDIO - Manual - 759
To Next Page
Loading...
Need help?
General
