Manually Adjusting Slices Using Your Controller
Your controller provides a dedicated Slice Edit mode that allows you to select and fine-tune
each particular Slice.
â–º
On the SLICE page of the Sampling mode, press Button 5 (EDIT) to enter/leave Slice Edit
mode.
→
When Slice Edit mode is active, Button 5 is fully lit and the EDIT label underneath is
highlighted.
The Edit mode in the SLICE page.
In Slice Edit mode following parameters and commands are available:
Parameter Description
SELECTION section
SLICE (Knob 1) Selects the Slice to edit. The display will show you which Slice is
currently selected. You can also use the pads to select Slices starting
from pad 1.
START (Knob 3) Adjusts the start point of the selected Slice. Hold SHIFT when
turning the Knob to adjust the parameter in finer increments. If the
start point of the Slice and the end point of the previous Slice are
still joined, moving the start point of the Slice simultaneously moves
the end point of the previous Slice, so that both Slices stay joined.
Sampling and Sample Mapping
Slicing a Sample
MASCHINE STUDIO - Manual - 852
To Next Page
Loading...
Need help?
General
