Editing Your Zones on Your Controller
At the bottom of the left display, the Zone settings allow you to adjust how each Zone should
be played back.
The Zone settings on the controller.
The various parameters always display the values for the focused Zone.
The parameters available in the Zone settings are spread over five pages.
â–º
Use the Page buttons on the left of the displays to select the desired page.
Page 1 – PLAY RANGE Parameters
The parameters in the PLAY RANGE page allow you to adjust the portion of Sample that will
be played back when the Zone is triggered.
The ZONE page on the controller – page 1 of 5: PLAY RANGE parameters.
Sampling and Sample Mapping
Mapping Samples to Zones
MASCHINE STUDIO - Manual - 878
To Next Page
Loading...
Need help?
General
