Parameter Description
END (Knob 3) Adjusts the end point of the loop.
XFADE (Knob 4) Allows you to blend a little of the material near the loop start and
end points in order to get a smoother, less abrupt loop. This is
particularly helpful if the loop is inducing any clicks.
Hold SHIFT when turning the Knobs to adjust the parameters in finer increments.
By moving the loop’s start and end points closer to each other you can shrink the loop to
very small values on-the-fly, thereby creating very interesting glitch effects in a live sit-
uation.
Page 3 – TUNE / MIX Parameters
The TUNE / MIX page contains parameters controlling pitch- and level-related aspects of the
Sample playback.
The ZONE page on the controller, page 3 of 5: TUNE / MIX parameters.
Parameter Description
TUNE (Knob 1) Sets the tuning of the focused Zone.
GAIN (Knob 2) Sets the gain of the focused Zone.
Sampling and Sample Mapping
Mapping Samples to Zones
MASCHINE STUDIO - Manual - 880
To Next Page
Loading...
Need help?
General
