NEC Electra Elite IPK II System - Page 1018

Document Revision 4C Electra Elite IPK II
2 - 994 Trunk Group Routing
 25-10-01 Trunk Group Routing for DISA
Assign the Trunk Group Route chosen when a user places a DISA call into the system and dials
9. The Trunk Group Routing is defined in Program 14-06. If the system has ARS, dialing 9
accesses ARS. The route chosen is based on the DISA Class of Service, which is determined by
the password the caller dials.
Trunk Group Routes: 1~100
(default: 1)
 25-12-01 Alternate Trunk Group Routing for DISA
Define the trunk route selected when a DISA caller dials the Alternate Trunk Access Code
assigned in Program 11-09-02. The route selected is based on the DISA caller’s Class of
Service, which is in turn determined by the password the caller dials. Program 14-06 is used to
set up the Trunk Group Routing.
Trunk Group Routes: 1~100
(default: 1)
 34-03-01 Trunk Group Routing for E&M Tie Lines
Assign the Trunk Group Route chosen when a user seizes a Tie Line and dials 9. Set Trunk
Group Routing in Program 14-06. If the system has ARS, dialing 9 accesses ARS.
Trunk Group Routes: 1~100
(default: 1)
Operation
To place a call using Trunk Group Routing:
1. At the multiline terminal, press Speaker.
- OR -
At single line telephone, lift the handset.
2. Dial 9.
3. Dial number.
- OR -
1. At the multiline terminal, press Trunk Group Routing key (PRG 15-07 or SC 752: 05).
 Also refer to the Call Appearance (CAP) Keys on page 2-105.
2. Dial the number.