NEC Electra Elite IPK II System - Page 1088

Document Revision 4C Electra Elite IPK II
2 - 1064 Voice Mail Integration (Analog)
 20-03-01 System Options for Single Line Telephones – SLT Call Waiting Answer Mode
For a busy single line (500/2500 type) telephone, set the mode used to answer a camped-on
trunk call. The default setting should be used [0 = Hookflash (Hooking)].
(default: 0)
 20-06-01 Class of Service for Extensions
Assign a Class of Service (1~15) to the voice mail extensions. You should use COS 14 for all
time modes.
 20-11-01
through
20-11-05
20-11-12 Class of Service Options (Hold/Transfer Service)
Set these options to 0 (Off) for the voice mail COS (recommended).
 20-13-01
through
20-13-07
20-13-12
20-13-16
20-13-28
20-13-35 Class of Service Options (Supplementary Service)
Set these options to 0 (Off) for the voice mail COS (recommended).
 20-13-13 Class of Service Options (Supplementary Service) – Continued Dialing (DTMF) Signal on
ICM Call
Enable Continued Dialing (1) for all extensions that dial Voice Mail features.
(default: 1)
 22-02-01 Incoming Call Trunk Setup
 22-04-01 Incoming Extension Ring Group Assignment
To enable Voice Mail Overflow, assign selected extensions to a Ring Group that ring for
unanswered DILs to Voice Mail ports. In PRG 22-06, enter 1 to enable overflow ringing.
(default: Extensions 101~108 ring for Incoming Ring Group 1 calls. No other extensions ring for
Incoming Ring Group 1 Calls.)
 22-07-01 DIL Assignment
Assign destination extension (up to eight digits).
(default: No Setting)
 22-08-01 DIL/IRG No Answer Destination
For Voice Mail Overflow, enter the Ring Group that unanswered DILs to Voice Mail ring after the
DIL Call Waiting time (PRG 22-01-04).
(default: 1)