NEC Electra Elite IPK II System - Page 1110

Document Revision 4C Electra Elite IPK II
2 - 1086 Voice Over Internet Protocol (VoIP)
Programming – Using the Electra Elite IPK II DHCP
 10-13-01 In-DHCP Server Setup – DHCP Server Mode
Enable (1)/Disable (0) the system ability to use the built-in DHCP server. The system must be
reset for the change to take effect.
(default: 0)
 10-13-02 In-DHCP Server Setup – Lease Time
Enter the lease time of the IP address to a client . The system must be reset for the change to
take effect.
(default: 0 days, 0 hours, 30 minutes)
 10-13-04 In-DHCP Server Setup – Number of Networks
Select the number of networks in use on the system (0=Single Network, 1=Divide Same
Network). The system must be reset for the change to take effect.
(default: 0)
 10-14-01 Managed Network Setup – The range of the IP address to lease
Set the range of IP addresses available to be used by the DHCP server for Scope 1.
(default: Minimum = 172.16.0.100, Maximum = 172.16.5.254. Scopes 2~10 = 0.0.0.0)
 10-15-01 Client Information Setup – The IP address should be assigned out of the scope range of
Program 10-14
Set the IP and MAC addresses for each client (up to 10) when the DHCP server needs to assign
a fixed IP address to clients.
(default: MAC:00-00-00-00-00-00, IP:0.0.0.0)
 10-16-01 Option Information Setup – Router
Set the router address for the DHCP server to the client.
[default: Code 3 (fixed) IP address = 0.0.0.0)]
 10-16-02 Option Information Setup – DNS Server
If required, set the DNS server address for the DHCP server to the client.
[default: Code 6 (fixed) IP address = 0.0.0.0)]
 10-16-03 Option Information Setup – TFTP Server (Version 1600 and 2100 or higher required)
[default: Code 66 (fixed) IP address = 0.0.0.0)]
 10-16-05 Option Information Setup – MGC
Set the MGC IP address for the DHCP server to the client.
[default: Code 129 (fixed) IP address = 172.16.0.10)]
Programming, Electra Elite IPK II IP Phone or Electra Elite IPK II Multiline Terminal with IP
Adapter – DHCP
Setting the IP Address on an Electra Elite IPK II IP Phone or Electra Elite IPK II multiline terminal with IP
Adapter Using a DHCP Server
1. On the Electra Elite IPK II IP multiline terminal, enter the telephone program mode by pressing
Hold Conf
 #.
 This enters the IP User Menu program mode to select the settings for the individual telephone.