NEC Electra Elite IPK II System - Page 1111

Electra Elite IPK II Document Revision 4C
Voice Over Internet Protocol (VoIP) 2 - 1087
2. Access Network settings and press 1 to enter the DHCP mode. If not flashing, press 2 to enable
the DHCP mode. Press the OK softkey.
 The flashing item is the current selection.
3. The entries for items 2, 3 and 4 are automatically set by the DCHP server.
4. The MGC IP Address is automatically set by the DHCP Server.
5. Press 3 to enter the IP telephone extension number.
6. Press the SAVE softkey to save the entries and return the telephone to idle.
 If a user’s LAN is already operating with a DHCP server, disable the Electra Elite IPK II DHCP server. Either
DHCP server can be used, but not both.
 When a user’s DHCP server is operating, make sure to define Program 10-16.
Programming – Using an External DHCP

If a user’s LAN is already operating with a DHCP server, disable the Electra Elite IPK II DHCP server. Either
DHCP server can be used, but not both.
Operation
None