Document Revision 4C Electra Elite IPK II
2 - 1116 Wireless - DECT
Programming Pause
A long press on
adds a pause to predial or phone book numbers.
Programming of two Different Setups
Each handset can program two profiles to control ring tone and vibrator. One can be an indoor
setting; the other, an outdoor setting.
Adjustable Volume
Ring volume can be adjusted using > and < in the profile setup.
Key Lock
Press Menu and
to lock the dial pad.
Nine Different Ring Tones
Ring tones can be selected using > and <.
Microphone Mute
Press OK while the telephone is off-hook to mute the microphone.
Caller ID Presentation
Headset Connection
Automatic Off-Hook
B-Answer can be turned On/Off using > and < in the profile setup. When set to On, the telephone
automatically goes off-hook when it rings.
R-Key for Transfer and Special Services
When off-hook, press R to Recall, transfer.
Base Station
The Base Station provides the link between the Wireless – DECT telephone and the Electra Elite IPK II
system. Base Stations are connected to the BSU( )-U20 ETU using standard two wire (twisted pair)
telephone cable, CAT 4 or CAT 5. The maximum distance from the BSU( )-U20 ETU to the Base Station
is 3,280 feet. Local power is not required because the Base Station receives power from the IPK II
system. Up to 16 Base Stations can be connected to the system. Each Base Station supports four
simultaneous IPK II Wireless – DECT traffic channels at 32 Kbs.
To Next Page
Loading...
