NEC Electra Elite IPK II System - Page 1176

Document Revision 4C Electra Elite IPK II
3 - 32 Codes Tables
Code: 27
Operation: Press
key + bin + Line or
Speaker key
Speed Dialing Dial a stored System Speed
Dialing number
None #2 + bin
Code: 28
Operation: Press
key + bin + Line or
Speaker key
Dial a stored Group Speed
Dialing number
None
#4 + bin
Code: 29
Operation: Place
call + Press key
Repeat Redial Activate repeat redial while
on a call
Fast Flash while
system waits to
redial
-
Code: 30
Operation:
Save
: Place call +
Press key
Redial: Line or
Speaker key +
Press key
Save Number Dialed Save, redial or check a saved
number
None 715
Code: 31
Operation:
Store
: While on call,
Press key + number
to store
Use: Press key +
Speaker key or line
Erase: Speaker key
+ Press key
Memo Dial Store, use or check a Memo
Dial number
None -
Code: 33
Operation: Call
ext. and receive
busy + Press key
Off-Hook Signaling Signal a busy extension None 709
Code: 34
Operation: Call ext
+ Press key
Barge-In Barge-In on a co-worker’s
conversation
None 710
Code: 35
Operation: Call
busy extension or
access busy trunk +
Press key
Callback / Camp-On /
Trunk Queuing
Leave a Callback request at
a busy extension, Camping
On to a busy extension,
Queuing for a busy trunk
On red when
activated
750
Code: 36
Operation: Dial
busy ext + Press
key
Department Step Calling Step Call through a
Department Group for an idle
member
None 708
Code: 37
Operation: Call
extension + Press
key
Call Forwarding / Do Not
Disturb Override
Override an extension Call
Forwarding or Do Not Disturb
On red when
activated
707
Table 3-5 Function Key Codes by Number (Continued)
To program a key, press Speaker key, dial 751 (for 2-digit codes) or 752 (for 3-digit codes),
press the key and enter the code (e.g., 48 for Voice Over).
Use this key... For this feature... When you... Key Lamp Status
Also see
Srvc Code