Document Revision 4C Electra Elite IPK II
2 - 174 Caller ID
Voice Mail Message Indication on Line Keys
Programming
10-02-04 Location Setup – Area Code (Version 1600 and 2100 or higher required)
Up to 6 digits (0~9,
, #) (default not assigned).
10-02-05 Location Setup – Trunk Access Code
For Electra Elite IPK II Wireless users, enter the trunk access code digits required to place an
outgoing call (eight digits maximum: 0~9,
, #). This code is added to the Caller ID information
for incoming ISDN trunk calls to allow the call to dial out.
10-09-01 DTMF and Dial Tone Circuit Setup
Allocate the circuits (1~16 or 1~64) on the CPUII ETU for either DTMF receiving or dial tone
detection (0 = Common Use, 1 = Extension Only, 2 = Trunk Only).
11-15-03 Service Code Setup, Administrative (for Special Access) – Backup Data Save
Back up the programmed data on the SRAM and Call History to the Flash ROM. While saving
the database, it may cause system lock up.
14-01-20 Basic Trunk Data Setup – Block Outgoing Caller ID
Allow (1)/Prevent (0) the system from automatically blocking outgoing Caller ID information
when a user places a call. If allowed (i.e., block enabled), the system automatically inserts the
Caller ID block code
67 (defined in Program 14-01-21) before the user dialed digits (this
requires Program 14-02-10 to be enabled). If prevented (i.e., block disabled), the system
outdials the call just as it was dialed by the user.
Trunks: 1~200
14-01-21 Basic Trunk Data Setup – Caller ID Block Code
Enter the code, up to eight digits, that should be used as the Caller ID Block Code. This code is
automatically inserted before dialed digits if Program 14-01-20 is set to 1.
Trunks: 1~200
14-01-22 Basic Trunk Data Setup – Caller ID to Voice Mail
Enable (1)/Disable (0) the system ability to send the Caller ID digits to voice mail.
Trunks: 1~200
14-02-10 Analog Trunk Data Setup – Caller ID
Enable (1)/Disable (0) a trunk ability to receive Caller ID name/number information. If this option
is set to 1, the system suppresses ringing and lighting for trunk calls for the first ring to receive
the Caller ID information.
Trunks: 1~200
When the destination is Voice Mail, Single Line Telephone with Caller ID or ACD, the system suppresses
ringing and lighting to receive the Caller ID. When the incoming call destination is a Multiline Terminal
or Normal Single Line Telephone (SLT with no Caller ID) the system does not suppress ringing and
lighting.
To Next Page
Loading...
