NEC Electra Elite IPK II System - Page 202

Document Revision 4C Electra Elite IPK II
2 - 178 Caller ID
6. Dial the Speed Dial bin in which the number is to be stored. If you press Hold, the next available
Speed Dial bin is used. The display shows:
 If all Speed Dial bins are used, the display shows TABLE IS FULL.
7. Press HOLD. The display shows:
8. Enter the name to be associated with the stored number.
SYS XXXX:
xxxxxxxxxxxxx
SYS XXXX
-
Table 2-5 Keys for Entering Names
Use this keypad digit . . . When you want to. . .
1
Enter characters:
1 @ [ ¥ ] ^ _ ` { | } Æ ¨ Á À Â Ã Ç É Ê ì ó
2
Enter characters: A-C, a-c, 2.
3
Enter characters: D-F, d-f, 3.
4
Enter characters: G-I, g-i, 4.
5
Enter characters: J-L, j-l, 5.
6
Enter characters: M-O, m-o, 6.
7
Enter characters: P-S, p-s, 7.
8
Enter characters: T-V, t-v, 8.
9
Enter characters: W-Z, w-z, 9.
0
Enter characters:
0 ! “ # $ % & ’ ( ) ô Õ ú ä ö ü


Enter characters:
 + , - . / : ; < = > ? B E  S  ¢ £
#
# = Accepts an entry (only required if two letters on the same key are needed
- ex: TOM). Pressing # again = Space. (In system programming mode, use
the right arrow Softkey instead to accept and/or add a space.)
CONF
Clear the character entry one character at a time.
HOLD
Clear all the entries from the point of the flashing cursor and to the right.