NEC Electra Elite IPK II System - Page 265

Electra Elite IPK II Document Revision 4C
Code Restriction, Dial Block 2 - 241
Operation
To set Dial Block:
1. At the multiline terminal, press Speaker.
- OR -
At the single line telephone, lift the handset.
2. Dial 600 (default).
3. Dial the 4-digit Dial Block Code (user defined).
4. Dial 1.
 Confirmation tone is heard.
5. Press Speaker or replace the handset to hang up.
To release Dial Block:
1. At the multiline terminal, press Speaker.
- OR -
At the single line telephone, lift the handset.
2. Dial 600.
3. Dial the 4-digit Dial Block code.
4. Dial 0.
 Confirmation tone is heard.
5. Press Speaker or replace the handset to hang up.
To set Dial Block from another extension:
1. At the multiline terminal, press Speaker.
- OR -
At the single line telephone, lift the handset.
2. Dial 601 (default).
3. Dial the 4-digit Dial Block code (as set in programming).
4. Dial the extension number to blocked.
5. Dial 1.
 Confirmation tone is heard.
6. Press Speaker or replace the handset to hang up.