Electra Elite IPK II Document Revision 4C
Conference 2 - 255
- OR -
Access outside call.
- OR -
Retrieve call from Park orbit.
 To get the outside call, you can either press a line key or press the Speaker key and dial 9, the Trunk Access Code
+ the trunk number (default #9). You can optionally go back to step 2 to add more parties to your Conference.
4. When called party answers, press the Conf softkey or Conf twice.
 If you cannot add additional parties to your Conference, you have exceeded the system’s Conference limit.
 If the call being added is busy/unanswered:
With an outside call, press the line or Call Appearance (CAP) key for a call previously added to the Conference.
The unanswered call will drop and the initiator will be back into the Conference call.
 Adding an Intercom call to an outside Conference call: Press the Conf softkey on the Multiline Terminal display
or Conf twice to re-establish the Conference. If using a non-display telephone, press Conf twice.
 With only Intercom calls in the Conference: Press Conf twice to re-establish the Conference. If the voice mail
answers, there is no way to drop that extension out. You need to drop the Conference call.
5. Repeat steps 2~4 to add more parties.
Single Line Telephone
1. Establish Intercom or trunk call.
2. Hookflash and dial
#1.
3. Dial extension you want to add.
- OR -
Access trunk call.
- OR -
Retrieve call from Park orbit.
4. Hookflash and repeat step 3 to add more parties.
- OR -
Hookflash twice to set up the Conference.
To Split (alternate) between the parties in Conference:
Multiline Terminal
1. Press Conf (Transfer) or Conference key (PRG 15-07 or SC 751: 07).
To Next Page
Loading...
Need help?
General
