Electra Elite IPK II Document Revision 4C
Conference 2 - 257
Single Line Telephone
1. Hookflash, and dial # 8.
2. Hang up.
To Barge-In to Conference Call:
1. Pick up the handset or press Speaker, and dial the service code (default = 710).
If the telephone does not have the proper COS, a warning tone is sent. After the user hangs up, the system
automatically places a Callback to the extension.
2. Dial the extension number or press a DSS key of a telephone in a Conference call.
When a new call is added to the conference, an intrusion tone is heard by all parties in the Conference,
depending on system programming, and all display multiline terminals show the joined party. If a Conference is
not possible:
the extension user will hears a warning tone
the DISA user is rerouted to the defined ring group
- OR -
the Tie Line user hears a busy tone.
- OR -
The following steps are not available for DISA or Tie Line trunks:
1. Dial the extension number of the internal party.
2. Dial the single digit service code, if programmed.
Instead of the single digit service code, the service code 710 can be dialed also at this point.
To Transfer a Call into a Conference:
1. While on a call, press Hold.
2. Dial the Transfer to Conference service code (default = 624).
If the telephone does not have the proper COS, a warning tone is sent. After the user hangs up, the system
automatically places a Callback to the extension.
The display shows the line Number, Number/Name and Extension Name/Number.
3. Dial the extension number or press a DSS key of a telephone within a Conference call.
If an error tone is heard, Barge-In is not enabled for the extension and the call cannot go through. Retrieve the
call by pressing the flashing line or Call Appearance (CAP) Key or hang up and the call recalls the extension.
When the call is transferred into the Conference, an intrusion tone is heard by all parties in the conference,
depending on the entries in Program 20-13-17 and Program 80-01, and all display multiline terminals show the
joined party.
To cancel the transfer, press the flashing line or Call Appearance (CAP) Key to retrieve the call.
4. Hang up.
To Next Page
Loading...
Need help?
General
