Document Revision 4C Electra Elite IPK II
2 - 356 Direct Station Selection (DSS) Console
When a multiline terminal user is on a call, they can press a DSS key for that station to
transfer to another station. It is not necessary to press Transfer to transfer to another
station using a DSS key.
When a multiline terminal user is on a call, they must press Transfer to transfer a call off site with
a DSS key.
Program 30-03-01: DSS Console Key Assignment, Key Number 001~114, Function
Number 95: Page Switching is not supported in Version 1600.
Pauses can be entered in the dial string of a DSS/One Touch button. The pause is entered
as P in the dial string and causes the system to wait three seconds before sending the rest
of the digits that follow the P (pause). Multiple pauses can be entered.
The @ can be entered in the dial string of a DSS/One Touch button. The @ only applies to
ISDN and Intercom calls. When using the @, the system waits for the destination to answer
(answer supervision), and then sends the rest of the digits.
Entering a P (pause) in a DSS/One Touch dial string can be used for CO calls, Intercom
calls, or after the @ for ISDN calls.
Default Setting
No DSS Consoles assigned (in Program 30-02-01).
All DSS Console key ranges are ports 1~200.
Once a DSS Console is enabled, the console keys are DSS keys (Program 30-03-01).
System Availability
Terminals
All Multiline Terminals
Required Component(s)
None
Related Features
Automatic Call Distribution (ACD)
Call Forwarding
To Next Page
Loading...
