Document Revision 4C Electra Elite IPK II
2 - 358 Direct Station Selection (DSS) Console
 30-02-01 DSS Console Extension Assignment – Extension Number
Designate the DSS Console installations (i.e., the extensions that have DSS Consoles
connected to them).
 30-03-01 DSS Console Key Assignment
Customize DSS Console keys to function as DSS keys, Service Code keys, Programmable
Function Keys, and One-Touch Calling keys. The key [when defined as a DSS/One-Touch key
(code 01)] can have any function up to four digits (e.g., extension number or Service Code). The
function information (such as extension number or Service Code) would then be entered as the
additional data.
 30-05-02
through
30-05-21 DSS Console Lamp Table
If required, customize the system DSS Console flash rates. This table also affects DSS/Hotline
key lighting for multiline terminals.
Operation
Calling an extension from your DSS Console:
1. Press the DSS Console key.
 If the call voice-announces, you can dial 1 to make it ring.
 If you do not have Handsfree, you must lift the handset to speak.
Answering a trunk call from your DSS Console:
1. Press the flashing DSS Console key assigned to the trunk.
 If you do not have Handsfree, you must lift the handset to speak.
Transferring a call using your DSS Console:
1. Place or answer the call.
2. Press Transfer.
3. Press the DSS key for the extension that receives the transfer.
Extension Busy Lamp Field
When the DSS key is...
On
Off
Flashing Fast
The assigned extension is...
Busy on a call
Idle
In Do Not Disturb
To Next Page
Loading...
Need help?
General
