NEC Electra Elite IPK II System User Manual

Document Revision 4C Electra Elite IPK II
2 - 400 D
term
Cordless Lite II Terminal
3. Press On/Off MUTE to select the displayed line key or feature.
4. When a Line key is assigned, press MUTE once to enter the Off-Hook Ringing ON or OFF Mode.
Press Ring/Vol to toggle between TALK for On or NO TALK for Off.
 TALK is selected when the F1~F4 function keys are programmed for CO or Call Appearance Keys. NO TALK is
selected when F1~F4 function keys are programmed for functions not requiring an off-hook state (e.g., Log On/
Off or DND.)
5. Press On/Off MUTE to advance to the next function key (F2 ~ F4).
6. After programming F4, press On/Off MUTE to advance to Global Off-Hook Ringing Assignment.
7. Press Ring/Vol to turn Global Off-Hook Ringing On or Off (LCD indicates ON or OFF as
appropriate).
8. Press TALK to exit.
 Function keys F1 ~ F4 can be programmed as Line Keys 1~16, Redial (LNR/SPD), Answer (ANS), Feature
(FNC), or Recall. When assigned, these keys operate the same as on an NEC Multiline Terminal.
 When initially installed, function keys F1~F4 default to Line keys 1~4 respectively and Off-Hook Ringing
defaults to ON.
 Global Off-Hook Ringing must be ON (default) for any function key to operate with off-hook ringing.
Switching Between the Desktop Multiline Telephone and the D
term
Cordless Lite Telephone
Using the Base Unit:
When the D
term
Cordless Lite II is associated with a Multiline Telephone the following is applicable:
 Switching between the cordless mode and desk mode must be done while both telephones are
idle.
 A call in progress cannot be switched between the D
term
Cordless Lite II and the associated
Multiline Telephone.
 Switching held calls between the D
term
Cordless Lite II Telephone and the associated Multiline
Telephone is not recommended because line key LED indications are not provided.
Switching from Multiline Telephone and D
term
Cordless Lite Telephone:
1. Press the Cordless button on the base unit.
- OR -
Press REDIAL key from the D
term
Cordless Lite II handset. 

This applies only if the REDIAL key is programmed to perform desk to cordless switching.
To switch from D
term
Cordless Lite II Telephone to Multiline Telephone:
1. Press the DESK button on the base unit.
For additional Operating Procedures, refer to the D
term
Cordless Lite II (DTH-4R-1) Owner’s Guide.

NEC Electra Elite IPK II System Specifications

General

Brand	NEC
Model	Electra Elite IPK II System
Category	Telephone System
Language	English