Document Revision 4C Electra Elite IPK II
2 - 448 Flexible System Numbering
Conditions
Programming follows a telephone extension number, not the port number in most cases. If
you relocate a telephone, you may need to change additional programming.
If the extension numbering plan is changed from 3xx to 2xx, and you want to consecutively
press two DSS keys without toggling the hookswitch, Program 11-16-05 must be removed.
If not, press the second DSS key to actually camp you on to the first extension.
Since making changes in Program 11-01 does not automatically make any changes in any
other program, changing the number plan after the system is in operation may cause
problems in the following programs:
11-20-01 Dial Extension Analyze Table
(Version 2000 or higher required)
Use tables 01 ~ 128 to assign the digits to be dialed using
the Dial Extension Analyze Tables. These tables are used
when Program 11-01-01 is set to option 9 = Dial Extension
Analyze.
(Up to eight digits can be assigned and the valid entries are:
0, 1 ~ 9,
#, , )
11-20-02 Dial Extension Analyze Table
(Version 2000 or higher required)
Assign the Type of Dial for the Dial Extension Analyze Table
from Program 11-20-01.
(Svc Code, Intercom, Operator, or F-Route)
11-10 Service Code Setup (for System Administrator)
11-11 Service Code Setup (for Setup/Entry
Operation)
11-12 Service Code Setup (for Service Access)
11-13 Service Code Setup (for ACD)
11-14 Service Code Setup (for Hotel)
11-15 Service Code Setup, Administrative (for
Special Access)
Customize the Service Codes.
11-16 Single Digit Service Code Setup Assign the Single Digit Service Code. This is the
post-dialing code a user can dial after placing an
Intercom call to a co-worker.
PRG 11-01 Type 2
(Extension Number)
PRG 11-01 Type 1
(Service Codes)
11-02 11-08 15-12 22-11 11-10 11-14 21-11
11-04 11-17 16-01-01 25-06 11-11 11-15 30-03
11-06 15-01-01 15-14 30-03 11-12 15-07
11-07 15-07 21-11 11-13 15-14
Flexible System Numbering (Continued)
Program Description
To Next Page
Loading...
