NEC Electra Elite IPK II System - Page 48

Document Revision 4C Electra Elite IPK II
2 - 24 Account Code – Forced/Verified/Unverified
4. Dial .
- OR -
Press your Account Code key (PRG 15-07-01 or SC 751: code 50).
5. Dial the number you want to call.
 If you hear “stutter” dial tone after dialing the number, ARS is requesting you to enter an Automatic Route
Selection Authorization Code. Refer to Automatic Route Selection on page 2-83 for more information.
To dial an outside number and let your system tell you when a Forced Account Code is required:
1. Access a trunk and dial the number you want to call.
 If you hear “stutter dial tone after dialing the number, ARS is requesting you to enter an ARS Authorization
Code. Refer to Automatic Route Selection on page 2-83 for more information.
2. Wait for your call to go through.
- OR -
3. If you hear “Please enter an Account Code,” (depending on system programming) and your
display shows ENTER ACCOUNT CODE.
 Dial .
- OR -
Press your Account Code key (PRG 15-07-01 or SC 751: code 50).
 Dial your Account Code (3~16 digits, using 0~9 and #).
If Account Codes are hidden, each digit you dial shows
 on the telephone display.
 Dial .
- OR -
Press your Account Code key (PRG 15-07-01 or SC 751: code 50).
To enter an Account Code for an incoming call:
This procedure is not available for single line telephones.
1. Answer incoming call.
 If Account Codes for Incoming Calls is disabled, the following steps dial digits out onto the connected trunk.
2. Dial .
3. Enter the Account Code (1~16 digits).
 You can enter any code of the proper length.
4. Dial .