NEC Electra Elite IPK II System - Page 483

Electra Elite IPK II Document Revision 4C
Flexible System Numbering 2 - 459
 11-16-01 Single Digit Service Code Setup – Step Call
Assign the Single Digit (post-dialing) Service Code.
 11-16-02 One-Digit Service Code Setup – Barge-In
Set up Item 02 for single digit Barge-In. For example, you can assign Item 02 to use digit 5 for
Barge-In. This allows you to program a function key with an extension number plus the Barge-In
code (i.e., 5). This allows one-touch access to the Barge-In feature for extension.
 11-16-03 Single Digit Service Code Setup – Switching of Voice/Signal Call
(Default: 1).
 11-16-04 Single Digit Service Code Setup – Intercom Off-Hook Signaling
Assign a one-digit service code to be used for Off-Hook Signaling.
 11-16-05 Single Digit Service Code Setup – Camp-On
Customize the 1-digit Service Code used for setting Camp-On.
(default: #)
Table 2-25 Service Code Setup, Administrative (for Special Access), Program 11-15
Item
No.
Item Terminals Default
Related
Program
01
Remote Maintenance
730
02
ACD Access in Dial-In Conversion Table
760 22-04
22-11
03
Backup Data Save
This option saves the user’s soft key settings (extension
programmed Call Forwards, DND, etc.). This feature should
be used before upgrading the system software.
MLT #  # 9
04
--- Not Used ---
05
System Programming Mode, Log-On
MLT #  #  11-01-01
06
Wake on LAN to APSU Unit
MLT No Setting 10-22
07
--- Not Used ---
08
--- Not Used ---
09
Transfer to Incoming Ring Group
No Setting
10
--- Not Used ---
11
Ethernet Port Reset
MLT, SLT No Setting
12
Extension Data Swap
MLT, SLT No Setting
13
--- Not Used ---
14
Modem Access
MLT, SLT 740