Electra Elite IPK II Document Revision 4C
Hold 2 - 495
Programming
11-12-30 Service Code Setup (for Service Access) – Specified Trunk Answer
If required, redefine the service code used to answer a specific trunk which is either ringing or on
hold (default: 672).
11-12-33 Service Code Setup (for Service Access) – Group Hold
If required, redefine the service code used to answer a specific trunk which is either ringing or on
hold (default: 732).
11-12-34 Service Code Setup (for Service Access) – Answer for Group Hold
If required, redefine the service code used to answer a specific trunk which is either ringing or on
hold (default: 762).
14-01-16 Basic Trunk Data Setup – Forced Release of Held Call
Enable (1)/Disable (0) Forced Release of Held Call.
14-07-01 Trunk Access Map Setup
Set up the Trunk Access Maps. This sets the access options for trunks on Hold.
Trunk Access Maps: 1~200
15-02-06 Multiline Telephone Basic Data Setup – Hold Key Operating Mode
Set the function of the extension Hold key:
0 = Normal Common
1 = Exclusive Hold
15-02-07 Multiline Telephone Basic Data Setup – Automatic Hold for CO Line
Determines whether an extension disconnects the trunk line (1) or automatically holds it (0)
when you direct select a CO line without placing the call on hold first. Automatic Hold does not
work until the elapse call timer is displayed.
15-02-11 Multiline Telephone Basic Data Setup – Callback Automatic Answer
Determine whether an extension answers (1) or does not answer (0) a call that is recalled when
you go off-hook.
15-06-01 Trunk Access Map for Extensions
Assign Trunk Access Maps to extensions.
Trunk Access Maps: 1~200
15-07-01 Programmable Function Keys
Assign a function key for Exclusive Hold (code 45). If an extension has its fixed Hold key
reassigned (in Program 15-02-06), assign a function key for System Hold (code 44).
16-02-01 Department Group Assignment for Extensions
Assign extensions to Department Groups.
Department Groups: 1~64
To Next Page
Loading...
