To Next Page

To Previous Page

Electra Elite IPK II Document Revision 4C

Intercom 2 - 517

 20-08-01 Class of Service Options (Outgoing Call Service) – Intercom Calls

Enable (1)/Disable (0) an extension user ability to place Intercom calls.

 20-08-11 Class of Service Options (Outgoing Call Service) – Protect for the Call Mode Switching

from Caller

When an extension is set to ring mode for ICM calls, enable this option to prevent callers from

changing the call to voice announce mode [Disable (0)/Enable (1)].

 20-11-07 Class of Service Options (Hold/Transfer Service) – Transfer Without Holding

Enable (1)/Disable (0) an extension user ability to Transfer a call without holding. If the Busy

Status Display feature is used, set this option to 0.

 20-13-22 Class of Service Options (Supplementary Service) – Busy Status Display (Called Party

Status)

Enable (1)/Disable (0) an extension user ability to use the Busy Status Display feature.

 20-17-01 Operator Extension – Operator’s Extension Number

Assign the operator’s extension. Default is 101.

 20-18-01 Service Tone Timers – Extension Dial Tone Time

Set the Extension Dial Tone Time (0~64800 seconds). After getting Intercom dial tone, a

multiline terminal user has this time to dial the first digit of the Intercom call. Default is 30.

 21-01-02 System Options for Outgoing Calls – Intercom Interdigit Time

Set the Intercom Interdigit Time (0~64800 seconds). When placing Intercom calls, users must

dial each digit within this time. Default is 10.

 82-01-01 Incoming Ring Tone – Frequency 1

Customize the Intercom ring tone.

 82-01-02 Incoming Ring Tone – Frequency 2

Customize the Intercom ring tone.

 82-01-03 Incoming Ring Tone – Modulation

For Handsfree Answerback/Forced Intercom Ringing:

 20-02-12 System Options for Multiline Telephones – Forced Intercom Ring (ICM Call Type)

Determine if an extension ICM calls should be set as Forced Intercom Ringing (1). If disabled

(0), Intercom calls voice-announce. For all NEC Cordless telephones, this option must be set to

1 as voice announce is impossible. Default is 0.

 20-06-01 Class of Service for Extensions

Assign a Class of Service (1~15) to an extension.

Default: Assign 101 as Class 15 and all others as Class 1.

 20-08-10 Class of Service Options (Outgoing Call Service) – Signal/Voice Call

Enable (1)/Disable (0) an extension user ability to toggle between Handsfree Answerback and

Forced Intercom Ringing for outgoing Intercom calls (dial 1). Default is 1.

NEC Electra Elite IPK II System User Manual

Questions and Answers: