NEC Electra Elite IPK II System - Page 573

Electra Elite IPK II Document Revision 4C
IP Station (MEGACO) – MG 16 2 - 549
 84-11-10 D
term
IP CODEC Information Basic Setup – G729 Jitter Buffer Average
Define G.729 Jitter Buffer average accepted value.
(default: 60 ms)
 84-11-11 D
term
IP CODEC Information Basic Setup – G729 Jitter Buffer Max
Define G.729 Jitter Buffer maximum accepted value.
(default: 120 ms)
 84-11-17 D
term
IP CODEC Information Basic Setup – Jitter Buffer Mode
Define the Jitter Buffer mode – support Static or Immediate.
[default: 2 (Immediate)]
 84-11-18 D
term
IP CODEC Information Basic Setup – VAD Threshold
Define the VAD Threshold Values. Consult the Electra Elite IPK II Programming Manual for
Threshold scale to set acceptable values.
[default: 20: 0dB (-30dBm)]
 84-11-26 D
term
IP CODEC Information Basic Setup – TX Gain
Define to TX Gain Values – Adjusting this value increases or decreases volume levels for the
receiving party. Consult the Electra Elite IPK II Programming Manual for Transmit Gail scale to
set acceptable value.
(default: 14)
 84-11-27 D
term
IP CODEC Information Basic Setup – RX Gain
Define to RX Gain Values – Adjusting this value increases or decreases volume levels for the
sending party. Consult the Electra Elite IPK II Programming Manual for Transmit Gail scale to
set acceptable value.
(default: 14)
 84-11-28 D
term
IP CODEC Information Basic Setup – Audio Capability Priority
(default: 0)